Weatherhawk 621 wireless heated weather station Bedienungsanleitung

Stöbern Sie online oder laden Sie Bedienungsanleitung nach Thermometer Weatherhawk 621 wireless heated weather station herunter. WeatherHawk 621 wireless heated weather station User Manual Benutzerhandbuch

  • Herunterladen
  • Zu meinen Handbüchern hinzufügen
  • Drucken
  • Seite
    / 3
  • Inhaltsverzeichnis
  • LESEZEICHEN
  • Bewertet. / 5. Basierend auf Kundenbewertungen
Seitenansicht 0
WeatherHawk®
815 W. 1800 N. Logan Utah 84321-1784, Email: service@weatherhawk.com Copyright © 2004 - 2013
Toll free in USA: 866-670-5982, International: 435-227-9802, FAX: 435-227-9749 Printed November 2012
Quick Start Guide Series 600 - Models 610/611/620/621
Computer Requirements
Available Serial Port or USB Port (Serial-to-USB onverter required)
WeatherHawk Setup Procedure
1. Remove the top foam packing from the WeatherHawk box and verify you have all ordered equipment.
Your system may have a wireless receiver (Model 620/621), and/or a solar panel (P/N 16851). Figure 1
below shows a wireless Model 620 with solar panel. Unpack all equipment and check for physical damage.
a. Lift the WeatherHawk by the main body of the weather station. Removing the station by lifting on
the sensors may damage the sensors (see Figure 1).
b. Avoid striking or resting the WeatherHawk on the domed top of the weather station.
c. Report missing or damaged equipment to WeatherHawk Customer Service before installing your
system.
.
d. A black rubber mast shim is inside the WeatherHawk
Integral mast mount. This shim reduces the diameter
to accommodate a 1 ¼ inch OD mast. Discard the shim
if using a 1 ¾ inch mast. Fully seat the shim on the mast,
with the flange down, before sliding the WeatherHawk
over the shim/mast.
2. Install your application software on your computer.
3. Connect the serial cable male connector to the WeatherHawk RS-232 port and the serial cable female
connector to a computer serial port (Figure 2).
Figure 2: Serial cable (left) and the
WeatherHawk serial port in which the serial
cable male connector connects. A dust cover
must be removed from the WeatherHawk
RS-232 port before connecting the cable.
Figure 1 Model 620 with solar panel
Seitenansicht 0
1 2 3

Inhaltsverzeichnis

Seite 1 - WeatherHawk Setup Procedure

WeatherHawk® 815 W. 1800 N. Logan Utah 84321-1784, Email: [email protected] Copyrigh

Seite 2 - WeatherHawk®

WeatherHawk® 815 W. 1800 N. Logan Utah 84321-1784, Email: [email protected] Copyrigh

Seite 3 - Help and Support

WeatherHawk® 815 W. 1800 N. Logan Utah 84321-1784, Email: [email protected] Copyrigh

Kommentare zu diesen Handbüchern

Keine Kommentare